Ask-proxima C180 UG Manuel d'utilisateur télécharger pdf (Page 37)

Network: The C180 has an RJ45 Ethernet connector that supports network

connections and TCP/IP protocols. This will allow for the control and man-

agement of the projector over a corporate network. The following fields are

accessible when DHCP is not checked and available for manual entry of

data.

IP Address: Identifies the projector on the network.

Subnet mask: Separates the network address part of the IP address.

Default gateway: The IP address of the local router.

DHCP: Select this to automatically obtain an IP address, Subnet mask,

and Default gateway.

Network Info: Provides information on the network configuration.

The Network Info menu is informational and cannot be edited. It displays

the current IP Address, Subnet Mask, Default Gateway, and the projector’s

MAC Address.

Language: allows you to select a language for the onscreen display of

menus and messages.

Service: to use these features, highlight them and press Select.

Factory Reset: restores all settings (except Lamp Hours and Network set-

tings) to their default after displaying a confirmation dialog box.

Reset Lamp: resets the lamp hours counter in the About menu to zero. Do

this only after changing the lamp. It displays a confirmation dialog box.

Service Info: provides information about the projector’s software version

and the active source.

Service Code: only used by authorized service personnel.

Network

Info

Language

Service menu

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 48 49

Pas de commentaire

Ask-proxima C180 UG Manuel d'utilisateur Page 37