Ask-proxima DP5950 Manuel d'utilisateur télécharger pdf (Page 48)

LAMP REPLACEMENT

If the lamp fails to come on and the lamp monitor on the projector Ight is orange, you ¡musí replace the buib.

For continued safety, replace with a lamp assembly of the same type.

• Allow the projector to coof for at least 45 minutes before you open the lamp cover. The

inside of the projector can become very hot.

• Do not drop the lamp module or touch the glass bulb ! The glass can shatter and cause

injury.

Follow these steps to replace the (amp assembly.

. Turn off the projector and allow the projector to cool thoroughly,

2. Disconnect the AC cord from the projector.

13. Remove screw with a screwdriver and disconnect the lamp cover.

4. Remove 2 screws with a screwdnver and pull out the lamp assembly by

grasping the handle.

5. Replace the lamp assembly.

6. Tighten 3 screws to secure the tamp cover to the lamp assembly.

7. Connect the detachable AC cord to the projector.

LAMP REPLACEMENT

INDICATOR

LAMP

8. Reset the lamp replacement monitor timer. (See "LAMP AGE" section on page 46.)

NOTE; Do not reset the LAMP REPLACEMENT MONITOR TIMER, except after the lamp is replaced.

-48 —

1 2 ... 43 44 45 46 47 48 49 50

Pas de commentaire

Ask-proxima DP5950 Manuel d'utilisateur Page 48